Hey guys, I have a bunch of injectors that I have serviced waiting to make power in someones motor All injectors have undergone the following process on my own personal ASNU injector diagnostic/flow bench:

- Resistence and continuity checked
- Hand cleaned, degreased, and visually inspected
- Ultrasonically cleaned for 30min while pulsed and back flushed(3 different 10min cycles)
- Flow pattern checked for consistency
- Flow tested and matched within 2% (factory usually matches from 3-5% variance)
- High pressure, and low pressure leak down tested.
- Dynamic flow patern test with drive simulation from 600-10000 RPM
- New filter baskets installed, and any damaged or broken pintle caps replaced
- Metal body injectors undergo a machine polishing
- re-inspected and prepped for storage


1) 19lb/hr UPGRADE BOSCH Design II Metal body, Yellow top, 4-pintle design. These are an upgrade from the single pintle design 19lb hr injector found in most 86-95 Mustangs. This upgrade will result in smoother idle, better throttle response, higher fuel milage, and more power due to the better fuel atomization of the 4-pintle deisgn. No other mods needed. $100 set of 8 - SHIPPED

2) 19lb/hr UPGRADE BOSCH Design III, plastic body, yellow, 4-pintle design. These are essentially the same as the above injector, with all the same performance gains, but in an all plastic, slimmer body style. They also utilize a lighter plunger which allows them to be more precise at narrower pulse widths (higher RPM) They also keep the fuel cooler because they do not become heat soaked. $120 set of 8 - SHIPPED

3) 24lb/hr BOSCH/Ford motor sport, Blue top, fuel injectors. These are great for a heads/cam/intake set-up. Also a great upgrade if you plan on adding a small amount of boost(use with FMU). These are genuine FORD fuel injectors. Your will need a MAF calibrated for 24lb injectors, or a chip in order to run these properly. $150 for set of 8 - SHIPPED

4) 24lb/hr BOSCH/Ford motorsports, Blue top, DESIGN III fuel injectors. These are essentially the same as the above injector but in an all plastic, slimmer body style. They also utilize a lighter plunger which allows them to be more precise at narrower pulse widths (higher RPM) They also keep the fuel cooler because they do not become heat soaked. $160 set of 8 - SHIPPED

5) 30lb/hr BOSCH Grey top fuel injectors. These are the metal body DESIGN II style with the 4-pintle spray. These are great for a heavy breathing heads/cam/intake set-up. Also a great upgrade if you plan on adding a some boost. These are genuine BOSCH fuel injectors usually used in the supercharged 3.8L GM motor. Your will need a MAF calibrated for 30lb injectors, or a chip in order to run these properly. $210 for set of 8 - SHIPPED

Please Email me at ohno5oh@shaw.ca if you are interested