Well I have decided to sell my Mustang. This was not an easy decision and took a lot of consideration. I have put a lot of time and money into this car so if I can’t find a buyer I may decide to part it out and then sell the rest as a roller. This car would make an excellent and easy to finish winter project for anyone.

The car is about 90% complete and needs the following work done:
•Install exhaust
•Front end alignment
•Finish assembling wires and miscellaneous small parts under the hood
•Paint (body work has been done and the car has been primered; the doors, engine bay and trunk have been painted Viper GTS Blue)

Exterior/Interior
Five lug four-wheel disc brake conversion
2002 factory Mustang GT Bullit wheels
Front tires are 245/40R17
Rear tires are Nitto Drag Radials (275/40R17)
Fully loaded with black interior
Dual 2 ½" gauge pillar pod with oil pressure and water temperature gauges

Motor
Rebuilt 302 (approximately 1000 miles)
E303 camshaft
Ported Ford Motorsports Y303 cylinder heads with Crane 1.6 roller rockers
Ported Ford Motorsports Cobra intake manifold (polished)
Kirban adjustable fuel pressure regulator
Walbro 255 lph fuel pump
Ford Motorsports 24 lbs fuel injectors
Pro-M mass air meter calibrated for 24 lbs fuel injectors
BBK cold air induction kit
BBK 65 mm throttle body
Anderson Motorsports polished valve covers
Ford Motorsports 9 mm wires
Electric fan
3G alternator upgrade
BBK full length 1 ⅝” long tube headers
Dr Gas 2.5” x-pipe
Dr Gas 2.5” flow tubes (2)
Spintech Sportsman series mufflers (2)
Note: All exhaust parts are brand new and have never been used.

Transmission
Rebuilt T-5 Transmission with upgraded steel input shaft
King Cobra clutch
B&M Ripper shifter
Ford Motorsports aluminum driveshaft
3.73 gears

Suspension
Front and rear coil overs
Lakewood 50/50 drag shocks
Mac upper and lower control arms
Maximum Motorsports tubular A-arms
Upgraded front sway bar

As far as price goes, I am open to negotiate with any serious buyers. I also have many other aftermarket performance parts that I haven’t installed on the car yet that we can also negotiate. Car is located in Winnipeg.

bradweiser66@hotmail.com