Brand New C&L 73mm MAF with 19lb tube (still in box). Looking to recoup what I paid...$180 or best offer.


FROM C&L:

1986-1993 5.0L MUSTANGS

Owners of fox body Mustang vehicles who want to maintain their original inlet plumbing or use another manufacturers inlet pipe have two choices when it comes to upgrading their factory mass airflow unit. We offer the 73mm which delivers a noticeable improvement in performance on both stock and modified 5.0 Mustang vehicles. The factory 55mm unit on these vehicles flows 550 cfm and is actually 5mm smaller than the stock throttle body. The 73mm unit flows 700 cfm and it is a direct fit replacement for the factory 55mm unit.

Dyno testing by us, our distributors and the major magazines have shown that by replacing the stock unit with one of our 73mm units, you can expect 8 more rear wheel horsepower. The difference in performance is not primarily due to the increase in airflow, but rather through a slightly more refined calibration. The original 73mm units calibration was developed using flowbench and track test data.

 

Do you have a pic?

 

I don't have a pic of the actual unit but can take one in a couple days. Here is a pic from the C&L website. It's the same item. It's brand new in the box which I opened to take a look at the unit and check that it was shipped intact. I changed my mind after I received it and went with a bigger C&L unit so never had to install it.

Your 93 only has 25K? Is that the original engine? If so, that 's impressive.

[IMG][/IMG]

 

Anyone want to upgrade to a NIB 73mm with torque bit and instructions still in the box? Never installed!

Also looking to trade if anyone has a FMS 65mm TB for a fox.

I installed a C&L 76mm on my car tonight and it runs well with the K&N Filtercharger Kit I have (open filter).

 

Sorry, didn't mention price: $175 shipped

 

Do you still have it???

 

Sorry man...was sold a couple days ago.

 

That's cool....thanks Mike